【24h】

EFFECTS OF LUBRICANTS ON THE FRICTION AND WEAR PROPERTIES OF PTFE AND POM

机译:润滑剂对PTFE和POM摩擦磨损性能的影响

获取原文
获取原文并翻译 | 示例

摘要

The friction and wear properties of PTFE and POM were investigated using a ball-on-steel ring tester under dry conditions and conditions lubricated by paraffin and 10W-30 oils. SEM, EDAX, FT-IR and surface wettability techniques were used to characterize and assess the morphology and chemical composition of the original surfaces as well as wear track, transfer film and wear debris for different loads and speeds. Although the friction was high, similar behaviours to those reported were observed. The experimentally determined surface temperature of the plastic revealed optimum loading levels for each sliding speed at which the friction and wear rates become minimal and the thermal effect stabilizes. In boundary-like lubrication using both oils, friction and wear were significantly reduced with the exception of an increase in wear rate with load when POM was lubricated with 10W-30 oil. Surface analysis revealed that the formation of lubricious protective layers on the surfaces in contact is crucial to reducing friction and more importantly wear. FT-IR results confirmed that film transfer occurs in the case of POM.
机译:在干燥条件下以及用石蜡和10W-30油润滑的条件下,使用钢球环测试仪研究了PTFE和POM的摩擦磨损性能。 SEM,EDAX,FT-IR和表面润湿性技术用于表征和评估原始表面的形态和化学成分,以及在不同载荷和速度下的磨损轨迹,转移膜和磨损碎屑。尽管摩擦力很高,但观察到的行为与所报道的相似。实验确定的塑料表面温度显示出每种滑动速度下的最佳负载水平,在这种速度下,摩擦和磨损率变得最小,并且热效应稳定。在同时使用两种油进行边界润滑的情况下,当用10W-30油润滑POM时,随负载的磨损率增加,摩擦和磨损得到了显着降低。表面分析表明,在接触的表面上形成润滑性保护层对于减少摩擦和更重要的磨损至关重要。 FT-IR结果证实在POM的情况下发生了膜转移。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号