• 主题
高级搜索  >
历史搜索 清空历史
首页> 外文会议>International Conference on Sciences and Techniques of Automatic Control and Computer Engineering >Design simulation and realization of solar battery charge controller using Arduino Uno
【24h】

Design simulation and realization of solar battery charge controller using Arduino Uno

机译：Arduino Uno的太阳能电池充电控制器设计仿真与实现

获取原文
页面导航
  • 摘要
  • 著录项
  • 相似文献
  • 相关主题

摘要

In this paper, a simple method battery charge controller has been designed to protect the battery from over-charging and deep discharges. The control of the process is entrusted to Arduino Uno board, that must be able to find out the battery state and determine when the charge process must be finished. The state of the battery is perfectly controlled all the time. The use of an Arduino Uno based on microcontroller has been considered in order to allow a good flexibility, to simplify the hardware required (only a few external components are used), and to provide an intelligent tool to undertake, through the programmed algorithm. A buck DCDC Converter has been used to step down voltage from the panel photovoltaic to charge voltage of the battery. This paper presents a comparison between the simulation and practical realization results of the device. A good agreement is obtained.
机译：本文设计了一种简单的电池充电控制器，以防止电池过度充电和深度放电。该过程的控制权交给Arduino Uno开发板，该开发板必须能够找出电池状态并确定何时必须完成充电过程。电池的状态始终处于最佳状态。已考虑使用基于微控制器的Arduino Uno，以提供良好的灵活性，简化所需的硬件（仅使用了几个外部组件），并提供了智能的工具来通过编程算法进行操作。降压DCDC转换器已用于将来自面板光伏的电压降低至电池的充电电压。本文介绍了该设备的仿真与实际实现结果之间的比较。获得了良好的协议。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号