• 主题
高级搜索  >
历史搜索 清空历史
首页> 外文会议>Third International Conference on Measurement and Control of Granular Materials (MCGM'93) October 15-17, 1993 Shenyang, P. R. China >Estimating the overflow and corrected cut size of hydrocyclone classification without product size measurement
【24h】

Estimating the overflow and corrected cut size of hydrocyclone classification without product size measurement

机译：无需测量产品尺寸即可估算水力旋流器分类的溢流量和校正后的切割尺寸

获取原文
获取原文并翻译 | 示例
页面导航
  • 摘要
  • 著录项
  • 相似文献
  • 相关主题

摘要

In mineral processing; chemical engineering and other powder production plants, it is very importnat and desirable to determine the overflow and corrected cut size of hydrocyclone classification. A new method was developed in order to estimate both of them without product size measurement in this paper. For a relatively stabilized grindinghydrocyclone classification system, if the operating and dimensional variables for a hydrocyclone classifier are known, the overflow and corrected cut size can be determined quickly with the method mentioned above. The verification experiments showed that the results of the estiamtion by this method are accurate and the relative errors are less than 5percent and 8percent for overflow and corrected cut size respectively.
机译：在矿物加工中；化学工程和其他粉末生产厂，确定旋流器分级的溢流量和正确的切割尺寸非常重要。为了在不进行产品尺寸测量的情况下估计两者，开发了一种新方法。对于相对稳定的研磨水力旋流器分级系统，如果知道水力旋流器分级机的操作和尺寸变量，则可以使用上述方法快速确定溢流量和校正后的切割尺寸。验证实验表明，该方法的估计结果是准确的，溢流和校正后的切块尺寸的相对误差分别小于5％和8％。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号