首页> 中文期刊> 《北京生物医学工程》 >轴流血泵入口管道流场的数值模拟与实验研究

轴流血泵入口管道流场的数值模拟与实验研究

         

摘要

Objective To study the blood flow distribution and the risk of thrombus generation in the inflow cannula of an axial blood pump. Methods The blood flow in the inflow cannula was simulated numerically by computational fluid dynamics( CFD) method to obtain the velocity distribution. Then the blood velocity distribution in the central section of the inflow cannula was obtained by two dimensional particle image velocimetry ( PIV) experiment. And the flow distribution in whole inflow cannula was tested with the three dimensional PIV system. The rotational speed of the blood pump was set to 8000 r/min with the flow rate of 5 L/min. Then the possibility of thrombus generation in the axial blood pump inflow cannula was estimated by analyzing the flow property in the inflow cannula. Results There was no spiral flow, backflow, vortex flow or low-speed flow region in the whole inflow cannula. The flow velocity along the cannula wall increased rapidly from 0 m/s to above 0.8 m/s outside the boundary layer. The blood velocity mainly distributed from 1.2 m/s to 1.4 m/s. The turbulence level in the inflow cannula is 0. 17. Conclusions It is hard to form thrombus in the cannula caused by worse blood flow property because there was no backflow, vortex flow or stagnant flow region in the inflow cannula. The inflow cannula can steady the flow entry the blood pump to improve the flow characteristic in the axial blood pump.%目的 研究轴流血泵入口管道内血流流场分布情况及血栓形成风险.方法 利用计算流体力学(computational fluid dynamics,CFD)模拟血泵及入口管道内流动情况,获取血流速度及其分布;用二维粒子成像测速(particle image velocimetry,PIV)系统测试轴流血泵入口管道中心截面内的血液流动情况及三维粒子成像测速系统测试整个管道内的血液流动情况.CFD计算和PIV实验中血泵的转速为8000 r/min,流量为5.0 L/min.通过分析入口管道内的流场分布评价血泵入口管道内的血栓形成风险.结果 整个入口管道内不存在回流、涡流和低速流动区域,血液沿管道的流动速度在管壁边界层外由0m/s迅速增大到0.8m/s以上.管道内的血液流速集中分布于1.2~1.5m/s范围,管道内的平均紊流度为0.17.结论 由于管道内的流动平稳且不存在回流、涡流和低速流动,因此不易形成血栓.入口管道使血流平稳,有助于改善轴流血泵内的流场.

著录项

  • 来源
    《北京生物医学工程》 |2018年第3期|228-234|共7页
  • 作者单位

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

    中国医学科学院阜外医院,北京协和医学院,国家心血管病中心,心血管疾病国家重点实验室 北京100037;

  • 原文格式 PDF
  • 正文语种 chi
  • 中图分类 生物力学;
  • 关键词

    轴流血泵; 数值模拟; 粒子成像测速; 入口管道; 血栓形成;

相似文献

  • 中文文献
  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号