首页> 美国卫生研究院文献>Springer Open Choice >Enhancing recovery and sensitivity studies in an unconventional tight gas condensate reservoir
【2h】

Enhancing recovery and sensitivity studies in an unconventional tight gas condensate reservoir

机译:加强非常规致密气凝析油藏的采收率和敏感性研究

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The recovery factor from tight gas reservoirs is typically less than 15%, even with multistage hydraulic fracturing stimulation. Such low recovery is exacerbated in tight gas condensate reservoirs, where the depletion of gas leaves the valuable condensate behind. In this paper, three enhanced gas recovery (EGR) methods including produced gas injection, CO2 injection and water injection are investigated to increase the well productivity for a tight gas condensate reservoir in the Montney Formation, Canada. The production performance of the three EGR methods is compared and their economic feasibility is evaluated. Sensitivity analysis of the key factors such as primary production duration, bottom-hole pressures, and fracture conductivity is conducted and their effects on the well production performance are analyzed. Results show that, compared with the simple depletion method, both the cumulative gas and condensate production increase with fluids injected. Produced gas injection leads to both a higher gas and condensate production compared with those of the CO2 injection, while waterflooding suffers from injection difficulty and the corresponding low sweep efficiency. Meanwhile, the injection cost is lower for the produced gas injection due to the on-site available gas source and minimal transport costs, gaining more economic benefits than the other EGR methods.
机译:即使采用多级水力压裂增产措施,致密气藏的采收率通常也低于15%。在致密的气体冷凝物储层中,如此低的回收率会加剧这种情况,因为气体的耗尽将有价值的冷凝物留在了后面。本文研究了三种提高采收率(EGR)的方法,包括采出气,CO2注入和注水,以提高加拿大Montney组致密气凝析油藏的井产量。比较了三种EGR方法的生产性能,并评估了其经济可行性。进行了诸如一次生产持续时间,井底压力和裂缝传导率等关键因素的敏感性分析,并分析了它们对油井生产性能的影响。结果表明,与简单的消耗方法相比,随着注入的流体,累积的气体和凝析油产量均增加。与二氧化碳注入相比,产生的气体注入会导致更高的气体和冷凝物生成量,而注水则存在注入困难和相应的低吹扫效率的问题。同时,由于现场可利用的气源和最小的运输成本,生产的气体喷射的喷射成本较低,与其他EGR方法相比,可获得更多的经济利益。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号