首页> 外文期刊>RSC Advances >Fe-MOFs prepared with the DBD plasma method for efficient Fenton catalysis
【24h】

Fe-MOFs prepared with the DBD plasma method for efficient Fenton catalysis

机译:用DBD等离子体法制备的Fe-MOFs有效地实现Fenton催化

获取原文
           

摘要

Fe-MOFs were successfully synthesized with the dielectric barrier discharge (DBD) plasma method, and applied for degradation of methyl orange by the Fenton process. Fe-MOFs were characterized by XRD, SEM, EDS, BET and FT-IR. A systematic study was carried out to optimize the synthesis conditions, taking into account the Fenton capacity performance for degradation of methyl orange. The optimal synthesis conditions were a discharge time of 100?min, discharge voltage of 18 kV, reactant concentration of 14 g L ~(?1) and reactant mass ratio (TA?:?FeCl _(3) ·6H _(2) O) of 1?:?5, with influence on the crystallization, morphologies and particle size. The degradation rate of methyl orange could reach 85% within 40 min with the MO concentration of 50 mg L ~(?1) , Fe-MOF dosage of 0.12 g L ~(?1) , pH of 5 and H _(2) O _(2) at 1 mL L ~(?1) . Meanwhile, the Fenton catalytic process was conducted covering a range of catalyst concentrations, initial MO concentrations, pH and H _(2) O _(2) amounts. Higher catalyst concentration, lower MO initial concentration, pH of 3 and H _(2) O _(2) amount of 1 mL L ~(?1) were conducive to the degradation efficiency.
机译:Fe-MOFs通过电介质阻挡放电(DBD)等离子体方法成功合成,并通过Fenton工艺用于降解甲基橙。 Fe-MOFs通过XRD,SEM,EDS,BET和FT-IR表征。考虑到Fenton降解甲基橙的能力,进行了系统研究以优化合成条件。最佳合成条件为:放电时间为100?min,放电电压为18 kV,反应物浓度为14 g L〜(?1),反应物质量比(TA?:?FeCl_(3)·6H _(2))。 O)为1?:?5,对结晶度,形态和粒径有影响。 MO浓度为50 mg L〜(?1),Fe-MOF剂量为0.12 g L〜(?1),pH为5和H _(2)时,甲基橙的降解率在40分钟内可达到85%。 O _(2)在1 mL L〜(?1)处。同时,进行了Fenton催化过程,该过程涵盖了催化剂浓度,初始MO浓度,pH和H _(2)O _(2)量的范围。较高的催化剂浓度,较低的MO初始浓度,pH值为3和H _(2)O _(2)的量为1 mL L〜(?1),有利于降解效率。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号