...
首页> 外文期刊>Coatings >Catalyzed HTPB/HDI-Trimer Curing Reactions and Influence on Pot Life
【24h】

Catalyzed HTPB/HDI-Trimer Curing Reactions and Influence on Pot Life

机译:催化HTPB / HDI-三聚制反应和对盆栽寿命的影响

获取原文
   

获取外文期刊封面封底 >>

       

摘要

In this research, rheokinetics is used to study the curing reaction of hydroxyl terminated polybutadiene (HTPB) and trimer of hexamethylene-1,6-diisocyanate (HDI-trimer) with 1,4-diazabicyclo[2.2.2]octane (DABCO) as catalyst under different catalyst mass fraction. The results show that the pot life of the system depends on the catalyst mass fraction in the binder system. Furthermore, with increased catalyst mass fraction, the fitting diagram obtained by plotting ln (viscosity) versus curing time shows a better linear relationship. Therefore, the amount of catalyst required to achieve a certain pot life can be calculated through the formula. It is worth mentioning that the applicable pot life equations are proposed in the paper. From the equations, we find that under isothermal curing conditions at 35 °C, when the mass fraction of DABCO was 0.216 wt.%, the pot life of the HTPB/HDI-trimer binder system reaches 4 h.
机译:在该研究中,使用1,4-二氮杂双环[2.2.2]辛烷值(DABCO)研究羟基封端的聚丁二烯(HTPB)和三聚二异氰酸酯(HDI-三聚体)的三聚体的固化反应和六亚甲基-1,6-二异氰酸酯(HDI-Trimer)的固化反应。不同催化剂质量分数下的催化剂。结果表明,该系统的罐寿命取决于粘合剂体系中的催化剂质量分数。此外,随着催化剂质量分数的增加,通过绘制LN(粘度)而获得的拟合图与固化时间表示更好的线性关系。因此,可以通过式计算实现某些罐寿命所需的催化剂的量。值得一提的是,本文提出了适用的盆栽寿命方程。从等式中,我们发现在35℃的等温固化条件下,当Dabco的质量分数为0.216重量%时,HTPB / HDI-三聚体粘合剂系统的罐寿命达到4小时。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号