...
首页> 外文期刊>ISIJ international >Effect of Additives on the Deposition Behavior and Micro Structure of Invar Fe–Ni Alloys with Low Thermal Expansion Electrodeposited from Watt’s Solution
【24h】

Effect of Additives on the Deposition Behavior and Micro Structure of Invar Fe–Ni Alloys with Low Thermal Expansion Electrodeposited from Watt’s Solution

机译:添加剂对低热膨胀型电沉积耐热膨胀的抗氟镍合金沉积行为及微结构的影响

获取原文
           

摘要

The electrodeposition of Invar Fe–Ni alloy with low thermal expansion was performed at 100–5000 A·m~(?2) and 10~(5) C·m~(?2) in agitated Watt’s solutions containing NiSO_(4), NiCl_(2), FeSO_(4), malonic acid (C_(3)H_(4)O_(4)), saccharin sodium (C_(7)H_(4)NNaO_(3)S), and H_(3)BO_(3) at 50°C. With increasing concentration of malonic acid, the Ni content in deposits formed at current densities greater than 2000 A·m~(?2) decreased, whereas the Ni content increased in deposits formed at current densities less than 1000 A·m~(?2). The current efficiency for alloy deposition decreased with increasing concentration of malonic acid. The deposits were composed of granular crystals whose size decreased with increasing concentration of malonic acid. With the addition of saccharin, the Ni content in the deposits decreased substantially, and the current efficiency for alloy deposition increased. With the addition of boric acid, the Ni content in the deposits somewhat decreased, and the current efficiency for alloy deposition increased. The surface morphology of deposits changed as the current density was varied and with the addition of saccharin, whereas it rarely changed with the addition of boric acid. The morphology was found to depend on the Ni content in the deposits. The deposits with a Ni content of 29–38 mass% were composed of granular crystals approximately 300 nm in size, whereas the deposits with a Ni content of 41–52 mass% exhibited a smooth surface that consisted of fine crystals. The effects of additives on the Ni content in deposits and current efficiency can be explained by the changes in the partial polarization curves for Fe and Ni depositions and H_(2) evolution during Fe–Ni alloy deposition.
机译:在含有NISO_(4)的搅拌瓦特溶液中,在100-5000 A·m〜(α2)和10〜(5)C·m〜(α2)下进行诸如·5000·m〜(α2)和10〜(5)C·m〜(α2)的电沉积。 NiCl_(2),FeSO_(4),丙酸(C_(3)H_(4)O_(4)),糖精钠(C_(7)H_(4)NNAO_(3)),H_(3) Bo_(3)在50°C。随着丙酸浓度的增加,在大于2000A·m〜(Δ2)的电流密度下形成的沉积物中的Ni含量降低,而在小于1000 a·m〜(?2的沉积物中,Ni含量增加。 )。随着丙酸浓度的增加,合金沉积的电流效率降低。沉积物由颗粒状晶体组成,其尺寸随着丙酸浓度的增加而降低。随着糖精的加入,沉积物中的Ni含量基本上降低,并且对合金沉积的电流效率增加。随着硼酸的加入,沉积物中的Ni含量稍微减少,并且对合金沉积的电流效率增加。随着电流密度改变的沉积物的表面形态变化,并加入糖精,而添加硼酸很少变化。发现形态取决于沉积物中的Ni含量。 Ni含量为29-38质量%的沉积物由粒状晶体的尺寸组成,而Ni含量为41-52质量%的沉积物表现出由细晶体组成的光滑表面。添加剂对沉积物和电流效率的Ni含量的影响可以通过Fe-Ni合金沉积期间的Fe和Ni沉积和H_(2)展示的部分极化曲线的变化来解释。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号