...
首页> 外文期刊>Energy & fuels >Aqueous CO_2 Foam Armored by Particulate Matter from Flue Gas for Mobility Control in Porous Media
【24h】

Aqueous CO_2 Foam Armored by Particulate Matter from Flue Gas for Mobility Control in Porous Media

机译:来自烟道气中的颗粒物质铠装摩尔,来自多孔介质中的迁移率控制的水性CO_2泡沫铠装

获取原文
获取原文并翻译 | 示例
           

摘要

Carbon dioxide (CO_(2)) is injected into reservoirs for enhanced oil recovery worldwide, which is an important technology to reduce carbon emissions from burning and consumption of fossil fuels. However, it is difficult to control the mobility of carbon dioxide in the formation, thus limiting its extensive utilization. In this work, particulate matter (PM) from flue gas was used to obtain an interfacial armored foam for controlling the CO_(2) mobility in porous media. Both homogeneous and heterogeneous porous model experiments were adopted to study CO_(2) foam flow behavior in porous media. Furthermore, the viscosity, interfacial viscoelasticity, and microstructure of foam were measured to help understand the mobility control mechanism. The results showed that the interfacial adsorption and compression of PM formed a particle armor on the CO_(2)-liquid interface, which improved foam film roughness and changed the interface to be more solid-like. Consequently, the viscosity of CO_(2) foams was increased by 2–13 times with the addition of 1.2 wt. % PM. In pore scale, the PM armored foams had stronger Jamin resistance and slipping resistance than bare surfactant foam. Thus, they showed relatively low mobility in porous media. The CO_(2) gas channel and water breakthrough were inhibited by the injection of 1 PV armored foams. The armored foams showed a higher resistance to the water flushing during the subsequent water flooding. The use of bare PM dispersions did not establish an effective flow resistance in the porous media. However, when a lower CO_(2) content (20% foam quality) was co-injected with the liquid phase, the improvement of foam resistance factor by adding PM was about 3 times upon addition of PM. Moreover, in the heterogeneous porous model, the mobility of fluids in the high permeability sandpack was effectively controlled by the armored foam, thus increasing the sweeping efficiency in the medium and low permeability sandpacks. Compared with bare surfactant foam flooding, the oil recovery by using armored foam was increased by about 21.3%. After flooding with armored foams, the residual resistance factors of armored foams were reduced to a lower level by enough subsequent water flooding, indicating the temporary plugging and low damage of armored foams in porous media. The significance of this research is the utilization of two important atmospheric pollutants by an inexpensive Pickering foam method for petroleum development and carbon sequestration.
机译:将二氧化碳(CO_(2))注入储层中,以加强全球的采油,这是减少燃烧和消费化石燃料的碳排放的重要技术。然而,难以控制在地层中二氧化碳的迁移率,从而限制了其广泛的利用率。在这项工作中,使用来自烟道气的颗粒物质(PM)来获得用于控制多孔介质中的CO_(2)迁移率的界面铠装泡沫。采用均相和异质多孔模型实验研究多孔介质中的CO_(2)泡沫流动。此外,测量泡沫的粘度,界面粘弹性和微观结构,以帮助理解迁移率控制机制。结果表明,PM的界面吸附和压缩在CO_(2) - 液体界面上形成了颗粒铠装,其改善了泡沫膜粗糙度并改变界面更加坚固。因此,CO_(2)泡沫的粘度增加了2-13次,加入1.2重量。 %PM。在孔隙尺度中,PM铠装泡沫具有较强的Jamin抗性和滑动性而不是裸表面活性剂泡沫。因此,它们在多孔介质中显示出相对低的迁移率。通过注射1个PV铠装泡沫来抑制CO_(2)气体通道和水突破。在随后的水驱期间,铠装泡沫表现出对水冲洗的抗性更高。裸PM分散体的使用在多孔介质中没有建立有效的流动性。然而,当用液相共同注射较低的CO_(2)含量(20%泡沫质量)时,通过添加PM加入PM的泡沫抗性因子的改善约为3倍。此外,在异构多孔模型中,通过铠装泡沫有效地控制了高渗透砂包中的流体的迁移率,从而提高了介质和低渗透砂包中的扫描效率。与裸露的表面活性剂泡沫洪水相比,使用铠装泡沫的储存量增加了约21.3%。通过装甲泡沫淹没后,通过足够的随后的水淹没降低了装甲泡沫的残留阻力因子,表明多孔介质中铠装泡沫的暂时堵塞和低损伤。该研究的意义是利用两种重要的大气污染物,通过廉价的石油发育和碳封存的催化泡沫方法。

著录项

  • 来源
    《Energy & fuels》 |2020年第11期|14464-14475|共12页
  • 作者单位

    Unconventional Petroleum Research Institute China University of Petroleum (Beijing);

    Unconventional Petroleum Research Institute China University of Petroleum (Beijing);

    Unconventional Petroleum Research Institute China University of Petroleum (Beijing)|College of Petroleum Engineering China University of Petroleum (East China);

    Petroleum Engineering Research Institute of Shengli Oil Field Sinopec;

    Unconventional Petroleum Research Institute China University of Petroleum (Beijing);

    College of Petroleum Engineering China University of Petroleum (East China);

    College of Petroleum Engineering China University of Petroleum (East China);

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号