Cut a 35mm length of the 07/16" x 20 Swg copper tube from the length supplied using a fine toothed hacksaw, taking care not to grip too tightly and deform the tube. Hold in a self-centring chuck with 5mm protruding and face off the sawn end using a sharp right-hand knife tool. Remove any sharp edges produced internally and externally. Turn the tube around. Hold in a self-centring chuck with 5mm protruding, face off end. Remove and measure. From this measurement deduct 32mm and re-chuck. Machine that amount from the tube. Remove any sharp edges produced internally and externally. Put to one side.
展开▼
机译:使用细齿钢锯从提供的长度上切下35mm的长度为07/16“ x 20 Swg的铜管,注意不要太紧地握住并使其变形。握住具有5mm突出且面朝下的自定心卡盘用锋利的右手工具将锯切的末端移去,将内部和外部产生的任何尖锐的边缘移开,将管子转过来,握住自定心卡盘,突出5mm,面朝下的一端,取出并测量,从此测量中减去32mm然后从管子上取下一定量,除去内部和外部产生的任何尖锐边缘,放在一侧。
展开▼