...
首页> 外文期刊>Fine woodworking >Level tablesaw wings for better cuts
【24h】

Level tablesaw wings for better cuts

机译:调平台锯机翼以获得更好的切割效果

获取原文
获取原文并翻译 | 示例
           

摘要

That is enough of a difference to cause problems, especially when crosscutting a rail, leg, or other long part. The edge of the table lifts the board, resulting in a cut that's not square. The solution is to loosen the bolts that hold the wing to the saw and shim the joint. Because the edges of your table are higher than the throat plate, put the shims above each bolt (if your wings sagged, the shims would go beneath the bolts). Use thin brass sheet material for the shims. You can buy it at hobby-supply stores. After shimming, check for flatness with a 36-in. straightedge.
机译:这足以引起问题,特别是在横切横杆,支腿或其他长零件时。桌子的边缘抬起木板,导致切口不平整。解决方法是松开将机翼固定在锯上的螺栓,然后对接缝进行垫片填充。因为桌子的边缘高于针板,所以将垫片放在每个螺栓上方(如果您的机翼下垂,垫片会落在螺栓下方)。垫片使用薄的黄铜板材料。您可以在业余爱好商店购买。填隙垫片后,用36英寸英寸检查平整度。直尺。

著录项

  • 来源
    《Fine woodworking》 |2012年第225期|p.89|共1页
  • 作者

    Roland Johnson;

  • 作者单位
  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号