...
首页> 外文期刊>Journal of Materials Research >In situ deposition of iron nanoparticles on transmission electron microscopy grid in furnace aerosol reactor
【24h】

In situ deposition of iron nanoparticles on transmission electron microscopy grid in furnace aerosol reactor

机译:铁纳米颗粒在熔炉气溶胶反应器中透射电子显微镜原位沉积

获取原文
获取原文并翻译 | 示例
           

摘要

In the current work, a device was proposed for the first time to deposit the panicles in situ on a transmission electron micrography grid within furnace aerosol reactors. The device was successfully tested on iron particles produced by thermal decomposition of Fe(CO)5 at 600 degreesC in a quartz tube heated by an electric heater. The particle depositions were made at four different spatial locations in the axial direction and investigated by transmission electron microscopy. At the reactor inlet, chain agglomerates of 2-3-nm particles were observed. At 19 cm from the inlet, the particles within the agglomerate structures fully coalesced by sintering, and at 32 cm (reactor outlet), polyhedral particles of about 100 nm in diameter emerged from the sintered body. [References: 7]
机译:在当前工作中,首次提出了一种装置,以将穗片原位沉积在熔炉气溶胶反应器内的透射电子显微照相板上。该设备已在由电加热器加热的石英管中在600摄氏度下热分解Fe(CO)5产生的铁颗粒上成功测试过。沿轴向在四个不同的空间位置进行颗粒沉积,并通过透射电子显微镜进行研究。在反应器入口处,观察到2-3-nm颗粒的链状聚集体。在距入口19 cm处,烧结过程中凝聚结构内的颗粒完全聚结,在32 cm(反应器出口)处,直径约100 nm的多面体颗粒从烧结体中冒出。 [参考:7]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号