Wear and corrosion behaviours of extruded Al-12Si-XMg alloys

Hayrettin Ahlatci

首页> 外文期刊>Materials Letters >Wear and corrosion behaviours of extruded Al-12Si-XMg alloys

【24h】

Wear and corrosion behaviours of extruded Al-12Si-XMg alloys

机译：Al-12Si-XMg挤压合金的磨损和腐蚀行为

获取原文

获取原文并翻译 | 示例

掌桥外文数据库（机构版） >>

开具论文收录证明 >>

文献代查 >>

页面导航

摘要
著录项
相似文献
相关主题

摘要

In this study mechanical and corrosion behaviours of Al-12Si-XMg alloys (where Mg contents varied up to 20%) have been investigated. The alloys were prepared by casting followed by extrusion at 300 ℃ with a ratio of 1.6. Precipitation of the Mg_2Si phases was observed in the Mg containing Al-12Si alloy matrix with two different morphologies; i.e. as a polyhedral primary particle and as a Chinese script. The amount and size of the primary Mg_2Si particles increased with increasing the Mg content, which was accompanied by an improvement in hardness and wear resistance but a reduction in corrosion resistance.

机译：在这项研究中，已经研究了Al-12Si-XMg合金（Mg含量变化高达20％）的力学性能和腐蚀行为。合金是通过铸造，然后在300℃以1.6的比例挤出而制备的。在具有两种不同形态的含Mg的Al-12Si合金基体中观察到Mg_2Si相的沉淀。即作为多面体基本粒子和中文文字。随着Mg含量的增加，初生Mg_2Si颗粒的数量和尺寸增加，硬度和耐磨性提高，但耐蚀性降低。

著录项

来源
《Materials Letters》 |2008年第20期|p.3490-3492|共3页
作者
Hayrettin Ahlatci;
展开▼
作者单位

Technical Education Faculty, Department of Metals, Karabuk University, 78100/Karabuk, Turkey;

展开▼
收录信息美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
原文格式 PDF
正文语种 eng
中图分类工程材料学;
关键词
Al-Si alloy; corrosion; Mg; Mg_2Si particles; wear;

机译：铝硅合金腐蚀镁Mg_2Si颗粒磨损;

相似文献

外文文献
中文文献
专利

1. Corrosion and corrosion wear behaviour of plasma carburised Stellite 21 Co-Cr alloy [J] . Chen J., Dong H. Tribology - Materials, Surfaces & Interfaces . 2009,第1期

机译：等离子渗碳Stellite 21 Co-Cr合金的腐蚀和腐蚀磨损行为
2. Effect of thermal oxidation on corrosion and corrosion-wear behaviour of a Ti-6Al-4V alloy. [J] . Guleryuz H, Cimenoglu HH Biomaterials . 2004,第16期

机译：热氧化对Ti-6Al-4V合金腐蚀和腐蚀磨损行为的影响。
3. Influence of Tungsten on Dry Sliding Wear Behaviour of Sintered/Hot Extruded P/M Alloy Steels (Fe-C-W-Ti) [J] . MK Sreelekh, S. Prathiba, M.A. Asokan, Materials Research . 2017,第4期

机译：钨对烧结/热挤压P / M合金钢（Fe-C-W-Ti）干滑动磨损行为的影响
4. Investigations on dry sliding wear behaviour of Sintered/Extruded P/M Alloy Steels (Fe-C-W-Ti) [C] . S. Senthur Prabu, S. Prathiba, Asokan M.A Global Congress on Manufacturing and Management . 2015

机译：烧结/挤出P / M合金钢的干式滑动磨损行为的研究（Fe-C-W-Ti）
5. Wear behaviour and microstructural characterization of worn surfaces and wear debris of a high purity aluminum and an aluminum-silicon alloy and an aluminum-silicon/silicon carbide composite sliding against an M2 steel. [D] . Li, Xianyao. 1999

机译：高纯铝，铝硅合金和铝硅/碳化硅复合材料在M2钢上滑动的磨损表面和磨损碎屑的磨损行为和微观结构表征。
6. Tensile Properties and Corrosion Behavior of Extruded Low-Alloyed Mg–1Sn–1Al–1Zn Alloy: The Influence of Microstructural Characteristics [O] . Weili Cheng, Yao Zhang, Shichao Ma, 2018

机译：挤压低合金Mg-1Sn-1Al-1Zn合金的拉伸性能和腐蚀行为：微观组织特性的影响
7. Development and Estimate of Extruded High Strength Al-Zn-Mg-La System Alloys with High Stress Corrosion Cracking Resistance. IV. Relationship between Fracture Toughness and Second Phase Particles in Extruded High Strength Al-Zn-Mg-Cu-La System Alloys with High Stress Corrosion Cracking Resistance. [O] . Yoichi KISHI, Yukio HIROSE, Ichizoh TSUKUDA, 1994

机译：高应力腐蚀裂纹抗裂性挤出高强度Al-Zn-Mg-LA系统合金的开发和估计。 IV。挤压高强度Al-Zn-Mg-Cu-La系统合金中断裂韧性和第二相颗粒的关系。
8. Use of Impedance Measurements in Corrosion Research: The Corrosion Behaviour ofChromium and Iron-Chromium Alloys (Gebruik van Impedantiemetingen voor Corrosieonderzoek. Het Corrosiegedrag van Chroom en Uzer-Chroom Legeringen) [R] . Dobbelaar, J. A. L. 1990

机译：阻抗测量在腐蚀研究中的应用：铬和铁铬合金的腐蚀行为（Gebruik van Impedantiemetingen voor Corrosieonderzoek.Het Corrosiegedrag van Chroom en Uzer-Chroom Legeringen）

Wear and corrosion behaviours of extruded Al-12Si-XMg alloys

摘要

著录项

相似文献

相关主题

期刊订阅