• 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Physical Review C: Nuclear Physics >Erratum: Collision energy dependence of viscous hydrodynamic flow in relativistic heavy-ion collisions [Phys. Rev. C 85, 054902 (2012)]
【24h】

Erratum: Collision energy dependence of viscous hydrodynamic flow in relativistic heavy-ion collisions [Phys. Rev. C 85, 054902 (2012)]

机译：勘误：相对论重离子碰撞中粘性流体动力流的碰撞能量依赖性[Phys。 Rev. C 85，054902（2012）]

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相似文献
  • 相关主题

摘要

We found an error in the computer program used to generate Fig. 4 in the above paper, which produced an incorrect resultnfor the solid blue curve corresponding to the MC-Glauber model. When calculating u0002pT u0003 from the single-particle spectra, weninadvertently put an extra pT weight in the calculation. So the solid blue curve in original Fig. 4 corresponds to u0002p2nTnu0003 [in (GeV/c)2].nThe corrected figure is shown here. After correction of the error, the difference between the MC-Glauber and MC-KLN modelsnis strongly reduced, and the mean pT for the MC-Glauber model is found to increase by 49% (from 0.45 to 0.67 GeV/c) overnthe covered energy range. The coding error affected only the calculation of the solid line in the attached figure but none of thenother results in the paper.nWe also overlooked stating the units on the axes of several other figures in our original publication. The units of the horizontalnaxes of Fig. 2 are fm−2. In Fig. 3, the horizontal axes have units GeV/c, while the vertical axes of Figs. 3(a) and 3(c) have unitsnof (GeV/c)−2. In Fig. 6, the units of the vertical axes are (GeV/c2)−2, and those of the horizontal axes are GeV/c2. In Fig. 7, thenhorizontal axes have units GeV/c2. Finally, the units of the horizontal axes in Fig. 8 are GeV/c. We regret these oversights.
机译：在上述论文中，我们在用于生成图4的计算机程序中发现了一个错误，该错误为与MC-Glauber模型相对应的纯蓝色曲线产生了错误的结果。从单粒子光谱计算u0002pT u0003时，会偶然地在计算中加上额外的pT权重。因此，原始图4中的蓝色实线对应于u0002p2nTnu0003 [in（GeV / c）2]。n此处显示了校正后的数字。校正误差后，MC-Glauber和MC-KLN模型之间的差异大大减小，并且在覆盖能量范围内，MC-Glauber模型的平均pT增加了49％（从0.45 GeV / c到0.67 GeV / c）。范围。编码错误仅影响附图中实线的计算，而本文中没有其他结果。n我们还忽略了原始出版物中其他几幅图的轴上的单位说明。图2的水平nax的单位是fm-2。在图3中，水平轴具有单位GeV / c，而图1和2的垂直轴具有单位GeV / c。 3（a）和3（c）的单位nof为（GeV / c）-2。在图6中，垂直轴的单位是（GeV / c2）-2，水平轴的单位是GeV / c2。在图7中，水平轴具有单位GeV / c2。最后，图8中水平轴的单位是GeV / c。我们对这些疏忽感到遗憾。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号