首页> 外文期刊>Power Electronics, IET >Reduced sensor configuration of brushless DC motor drive using a power factor correction-based modified-zeta converter
【24h】

Reduced sensor configuration of brushless DC motor drive using a power factor correction-based modified-zeta converter

机译:使用基于功率因数校正的改进型Zeta转换器减少了无刷直流电动机驱动器的传感器配置

获取原文
获取原文并翻译 | 示例
           

摘要

This study deals with the design and development of a power factor (PF) correction-based modified-zeta converter fed brushless DC (BLDC) motor drive. A single-phase supply followed by a diode bridge rectifier and a modified-zeta converter operating in discontinuous inductor current mode (DICM) is used to feed a voltage source inverter (VSI) driving a BLDC motor. The modified-zeta converter operating in DICM acts as an inherent PF pre-regulator. A single-voltage sensor is used for the DC-link voltage control, which is used to control the speed of the BLDC motor. This facilitates the operation of VSI in fundamental frequency switching for reducing the switching losses in VSI. The proposed BLDC motor drive is designed and its performance is simulated in MATLAB/Simulink environment for achieving an improved power quality at AC mains for wide range of speed control. The obtained power quality indices are under the recommended limits of international power quality standard IEC 61000-3-2. Finally, the performance of the proposed drive is validated with test results obtained on a developed prototype of the proposed BLDC motor drive.
机译:这项研究涉及基于功率因数(PF)校正的改进型zeta转换器馈电式无刷直流(BLDC)电机驱动器的设计和开发。单相电源后接一个二极管桥式整流器和一个在不连续电感器电流模式(DICM)下工作的改进型零点转换器,用于为驱动BLDC电机的电压源逆变器(VSI)供电。在DICM中运行的改进的Zeta转换器充当固有的PF预调节器。单电压传感器用于直流母线电压控制,用于控制BLDC电机的速度。这有助于基本频率切换中VSI的操作,以减少VSI中的切换损耗。设计了提出的BLDC电机驱动器,并在MATLAB / Simulink环境中模拟了其性能,以实现交流主电源的改进电能质量,从而实现了广泛的速度控制。获得的电能质量指标在国际电能质量标准IEC 61000-3-2的建议限制内。最后,通过在拟议的BLDC电动机驱动器的开发原型上获得的测试结果验证了拟议的驱动器的性能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号