...
首页> 外文期刊>Solid-State Electronics >Promotion of piezoelectric properties of lead zirconate titanate ceramics with (Zr,Ti) partially replaced by Nb_2O_5
【24h】

Promotion of piezoelectric properties of lead zirconate titanate ceramics with (Zr,Ti) partially replaced by Nb_2O_5

机译:用(Nb_2O_5)部分取代(Zr,Ti)的锆钛酸铅陶瓷的压电性能的提高

获取原文
获取原文并翻译 | 示例
           

摘要

This study investigated the correlation of sintering effects on piezoelectric properties of Nb modified lead zirconate titanate (PZT) piezoceramics produced by the conventional solid reaction sintering. Samples were prepared at a composition Zr/Ti = 53/47, contiguous to a morphotropic phase boundary (MPB) for 1 mol% Nb_2O_5. Replacement of Ti~(+4) by Nb~(+5) in such perovskite type solid solutions was accomplished by the creation of cation vacancies. These created vacancies seemed to facilitate material transport and benefit sintering. Calcined at 850℃/2 h and sintered at 1250℃/2 h, the PZT ceramics yielded a minimum value of the mechanical quality factor (Q_m) 50, and exhibited a maximum electromechanical coupling factor κ_p 0.62, in accordance with the relationship between the mechanical quality factor and electromechanical coupling factor. In addition, during the sintering process a piezoelectric charge constant at d_(33) was found to be of 385 pC/N. It was noted that the fundamental resonance frequency was around 200 kHz, which was suitable for piezoelectric nebulizer (fluid atomizer), ultrasonic cleaning transducer applications.
机译:这项研究调查了烧结效应与常规固相反应烧结生产的Nb改性锆钛酸铅(PZT)压电陶瓷的压电性能的相关性。制备的样品的组成为Zr / Ti = 53/47,与1 mol%Nb_2O_5的向晶相边界(MPB)相邻。在钙钛矿型固溶体中用Nb〜(+5)取代Ti〜(+4)是通过产生阳离子空位来实现的。这些空缺似乎促进了材料的运输并有利于烧结。 PZT陶瓷在850℃/ 2 h煅烧并在1250℃/ 2 h烧结,产生的机械品质因数(Q_m)最小值为50,并且最大电磁耦合系数κ_p0.62,这与PZT陶瓷之间的关系有关。机械品质因数和机电耦合因数。另外,在烧结过程中,发现d_(33)处的压电电荷常数为385 pC / N。值得注意的是,基本共振频率约为200 kHz,适用于压电雾化器(流体雾化器),超声清洗换能器应用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号