• 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>IEEE Journal of Solid-State Circuits >A 2x2 MIMO Tri-Band Dual-Mode Direct-Conversion CMOS Transceiver for Worldwide WiMAX/WLAN Applications
【24h】

A 2x2 MIMO Tri-Band Dual-Mode Direct-Conversion CMOS Transceiver for Worldwide WiMAX/WLAN Applications

机译：A 2x2 MIMO Tri-Band Dual-Mode Direct-Conversion CMOS Transceiver for Worldwide WiMAX/WLAN Applications

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

This paper describes a fully integrated 130 nm CMOS 2x2 MIMO tri-band dual-mode transceiver for fixed and mobile WiMAX and IEEE 802.11a/b/g/n applications. The proposed transceiver features reduced RF interface (only 4 RF pins) with the wideband circuit topology of the LNA and drive amplifier that minimizes the performance degradation. With carefully chosen LO frequency planning, the transceiver is capable of operating at 2.3–2.7 GHz, 3.3–3.9 GHz, and as well as 5.1–5.9 GHz bands covering whole frequency spectrum of fixed and mobile WiMAX and WLAN. The measured noise figure of the receiver is 3.6–4.2, 4.2–4.7, and 5.4–6.2 dB for each 2/3/5 GHz bands respectively. The measured PLL phase noise from 1 kHz to 10 MHz is 0.5/0.8/0.95 rms degree for 2/3/5 GHz bands respectively. The transceiver ensures low EVM over the wide dynamic range due to linear RX and TX signal paths and low integrated PLL phase noise characteristics.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号