...
  • 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Aerospace science and technology >Influences of microjet pressure and number of microjets on the control of shock wave/boundary layer interaction
【24h】

Influences of microjet pressure and number of microjets on the control of shock wave/boundary layer interaction

机译：Influences of microjet pressure and number of microjets on the control of shock wave/boundary layer interaction

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

Boundary layer separation is a common phenomenon in supersonic/hypersonic vehicles, and can adversely affect the lift coefficient. Currently, active flow control based on microjets is used to inhibit the separation of the turbulent boundary layer. The obtained results predicted by the three-dimensional Reynolds-averaged Navier-Stokes (RANS) equations and two-equation shear stress transport (SST) k-ω both with Realizable k-ε turbulence models show that the control mechanism of the microjets method is the counter-rotating vortex pair (CVP) generated by the microjet mixes the low-energy flow within the boundary layer with the high-energy flow near the boundary layer. The size of the vortex core in this CVP is the key to controlling SWBLI. The vortex nucleus that is larger and closer to the wall enables better SWBLI control. A lower or higher ratio of microjet pressure to inflow static pressure increases the total volume of the separation bubble and produces a negative gain. When the ratio of the triangular microjet hole bottom edge length to the spacing between the holes is too small, leading to a deterioration in the control effect. The addition of microjets reduces the total pressure recovery coefficient.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号