...
  • 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Energy conversion & management >Experimental investigation of the effects of preheating temperature on low-temperature cold start performance, emissions and energy conversion of diesel-electric hybrid
【24h】

Experimental investigation of the effects of preheating temperature on low-temperature cold start performance, emissions and energy conversion of diesel-electric hybrid

机译：Experimental investigation of the effects of preheating temperature on low-temperature cold start performance, emissions and energy conversion of diesel-electric hybrid

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

Low compression end temperatures, high heat loss, and large resistance torque cause difficulty in starting con-ventional diesel engines at extremely low temperatures. The diesel-electric hybrid is equipped with high-capacity battery, which can support high-energy-consuming preheating measures to improve low-temperature cold-start performance. However, only a few studies have been conducted on the effect of preheating on the low-temperature cold-start performance of diesel-electric hybrid. In this study, the influence of different preheat-ing temperatures on the performance, emissions, energy consumption, and conversion of a diesel-electric hybrid was experimentally investigated by designing an environmental simulation system and a preheating system. The results showed that intake air preheating consumed less energy and maintained a high energy conversion effi-ciency. As the intake air temperature increased, the combustion conditions improved, increasing the indicated mean effective pressure and enhancing combustion stability. However, intake preheating was invalid when the ambient temperature was below 244 K because of the high heat loss and large resistance torque. As the coolant temperature increased, the ignition delay period was significantly reduced, allowing the maximum pressure in the cylinder to increase. The corresponding position became closer to the top dead center, resulting in a steady increase in the speed rise rate, a reduction in hydrocarbon emissions from 1403 ppm to 298 ppm, and a reduction in opacity from 85% to 43%. The increase in the lubrication temperature mainly decreased the resistance torque, resulting in a reduction in the drag time and rise time of 0.37 s and 2.21 s, respectively. At 233 K, the minimum energy consumption of the combined preheating of the coolant and intake air was 2557 kJ. In contrast, the combined preheating of the lubricant and intake air was only 379 kJ, but the emission performance of coolant preheating was better than that of lubricant preheating. This result could be considered as the constraint boundary for optimizing the total equivalent energy consumption and is useful for optimizing the preheating strategy and development of diesel-electric-hybrid low-temperature thermal management.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号