• 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>The Journal of Prosthetic Dentistry >Accuracy of 3-dimensional printing of dental casts: A proposal for quality standardization
【24h】

Accuracy of 3-dimensional printing of dental casts: A proposal for quality standardization

机译：Accuracy of 3-dimensional printing of dental casts: A proposal for quality standardization

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

Statement of problem. A digital workflow in fixed prosthodontics may use a 3D printer to obtain a cast for porcelain application. Standards exist that define the accuracy of traditional casts, but the accuracy requirements of 3D-printed casts have not been defined. Purpose. The purpose of this retrospective study was to investigate how the accuracy of 3D-printed casts affected prosthesis fit and whether they correctly reproduced interproximal contacts. Material and methods. Copings with different die spacings were used to test different 3D-printed casts of the same dental arch. The accuracy of the 3D casts was assessed by imaging and comparing the resulting standard tessellation language (STL) files with the original through a matching software program. Accuracy scores were then correlated with a score measuring how well the copings fit the casts. The first data set was obtained from a patient receiving restoration of the 4 maxillary incisors. The teeth were prepared, the dental arch was imaged intraorally, and 10 resin casts were printed with four 3D printers. Two sets of 4 zirconia test copings were prepared, and 3 clinicians assessed their fit on each cast. A further set of casts was created from a second patient requiring prosthetic restoration for 5 adjacent teeth to assess whether undersizing affected the best fit of the copings on their dies. Results. The clinical scores and accuracy scores did not correlate. The results suggested that printed dies showing a certain degree of undersizing might provide a better fit than those showing better correspondence to the actual anatomic structure. The oversized dies were the worst. Only 7 of 17 casts being assessed were deemed suitable for veneering of the copings. The undersized casts tested clinically better than casts printed by using the same printer under standard settings. Conclusions. This retrospective study indicated that 3D-printed casts that do not allow copings to fit appropriately usually show mean excess oversizing. Axially undersizing the printed dies on casts might allow a better fit of copings to be veneered.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号