...
  • 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Chemosphere >Tailoring Fe_2O_3-Al_2O_3 catalyst structure and activity via hydrothermal synthesis for carbon nanotubes and hydrogen production from polyolefin plastics
【24h】

Tailoring Fe_2O_3-Al_2O_3 catalyst structure and activity via hydrothermal synthesis for carbon nanotubes and hydrogen production from polyolefin plastics

机译：Tailoring Fe_2O_3-Al_2O_3 catalyst structure and activity via hydrothermal synthesis for carbon nanotubes and hydrogen production from polyolefin plastics

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

Fe2O3-Al2O3 catalysts applied for conversion of polyolefin plastic waste into multi-walled carbon nanotubes (MWCNTs) and H-2 are typically produced by impregnation, co-precipitation or sol-gel synthesis at atmospheric pressure and temperatures below 100 C. This study utilized hydrothermal conditions and established the role of precipitating agents (urea, N-methylurea and N,N'-dimethylurea) on properties and catalytic activity of Fe2O3-Al2O3 catalysts (Fe-u, Fe-mu and Fe-dmu, respectively). The precipitating agent played a key role in tailoring the properties, such as crystallization degree, surface area and reducibility. The precipitating agents influenced the yield and outer diameters of MWCNTs but did not affect graphitization degree. Among the synthesized catalysts, Fe-u had the largest surface area and preferential formation of the highly reducible alpha-Fe2O3 crystalline phase. As a result, Fe-u had the highest activity during conversion of pyrolysis gas from low-density polyethylene (LDPE) into MWCNTs, yielding 0.91 g.g(-1)-catalyst MWCNTs at 800 C as compared to 0.42 and 0.14 g.g(-1) catalyst using Fe-dmu and Fe-mu, respectively. Fe-dmu favored the growth of MWCNTs with smaller outer diameters. Fe-u demonstrated high efficiency during operation using a continuous flow of pyrolysis gas from a mixture of polyolefins (70 wt polypropylene, 6 wt LDPE and 24 wt high density polyethylene) producing 4.28 g.g(-1)-catalyst MWCNTs at 3.2 plastic conversion efficiency and a stable H-2 flow for 155 min (25-32 vol ). The obtained data demonstrate that the selection of an appropriate precipitating agent for hydrothermal synthesis allows for the production of highly active Fe2O3-Al2O3 catalysts for the upcycling of polyolefin plastic waste into MWCNTs and H-2.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号