Thermal diffusivity measurement of stainless-steel alloys through use of the Angstrom's method

Ferreira-Oliveira J. R.; de Lucena L. R. R.; Dos Reis R. P. B.de Araujo C. J.Bezerra-Filho C. R.

首页> 外文期刊>Experimental heat transfer >Thermal diffusivity measurement of stainless-steel alloys through use of the Angstrom's method

【24h】

Thermal diffusivity measurement of stainless-steel alloys through use of the Angstrom's method

机译：Thermal diffusivity measurement of stainless-steel alloys through use of the Angstrom's method

获取原文

获取原文并翻译 | 示例

掌桥外文数据库（机构版） >>

开具论文收录证明 >>

文献代查 >>

页面导航

摘要
著录项
相关主题

摘要

The aim of this study is to estimate the thermal diffusivity of metallic materials, in particular AISI 304 and AISI 316 stainless steel. To this end, an experimental setup based on the Angstrom's method is used, where one face of a considerably large sample is subjected to a periodic heat flux and the other face is kept at a constant temperature. A low cost measurement system was developed to provide the fundamental requirements of the applied method. This consisted of thermophysical properties independent of temperature within the adopted measurement range, complete damping of the heat wave before it reaches the face at a prescribed temperature, one-dimensional heat transfer ensured by exposing the sample side to a vacuum or by thermal insulation. Following this, the feasibility of these scenarios was assessed. In order to conclude the proposed testing, thermocouples are fixed at specific locations on the exterior of the sample, for measuring the amplitude and phase of the thermal wave resulting from periodic heating at a certain frequency. The measurements carried out on a permanent periodic regime are inserted into a mathematical model so that the thermal diffusivity can be determined by linear regression. The results obtained for the two materials under analysis showed good agreement with the literature, with absolute deviations below 5.5 , proving the effectiveness of the experimental arrangement. Uncertainty quantification, assessed by the Monte Carlo Method, indicates a greater dispersion of the results when using the vacuum. Therefore, thermal diffusivity was estimated with greater precision and reliability, with thermal insulation applied to the side of the sample.

著录项

来源
《Experimental heat transfer》 |2022年第4期|419-439|共21页
作者
Ferreira-Oliveira J. R.; de Lucena L. R. R.; Dos Reis R. P. B.de Araujo C. J.Bezerra-Filho C. R.;
展开▼
作者单位

Univ Fed Uberlandia;

Univ Fed Campina Grande;

Fed Rural Univ Semi Arid;

展开▼
收录信息美国《科学引文索引》(SCI);美国《工程索引》(EI);
原文格式 PDF
正文语种英语
中图分类
关键词
Angstrom; 8217; s Method; Thermal Wave; Thermophysical Properties; Experimental Setup; Uncertainty Quantification;

Thermal diffusivity measurement of stainless-steel alloys through use of the Angstrom's method

摘要

著录项

相关主题

期刊订阅