...
首页> 外文期刊>Environmental Science & Technology: ES&T >On-road particulate matter (PM2.5 and PM10) emissions in the Sepulveda Tunnel, Los Angeles, California
【24h】

On-road particulate matter (PM2.5 and PM10) emissions in the Sepulveda Tunnel, Los Angeles, California

机译:On-road particulate matter (PM2.5 and PM10) emissions in the Sepulveda Tunnel, Los Angeles, California

获取原文
获取原文并翻译 | 示例
           

摘要

Total and speciated particulate matter (PM2.5 and PM10) emission factors from in-use vehicles were measured for a mixed light- (97.4 LD) and heavy-duty fleet (2.6 HD) in the Sepulveda Tunnel, Los Angeles, CA. Seventeen l-h test runs were performed between July 23, 1996, and July 27, 1996. Emission factors were calculated from mass concentration measurements taken at the tunnel entrance and exit, the Volume of airflow through the tunnel, and the number of vehicles passing through the 582 m long tunnel. For the mixed LD and HD fleet, PM2.5 emission factors in the Sepulveda Tunnel ranged from 0.016 (+/-0.007) to 0.115 (+/-0.019) g/vehicle.km traveled with an average of 0.052 (+/-0.027) g/vehicle.km. PM10 emission factors ranged from 0.030 (+/-0.009) to 0.131 (+/-0.024) g/vehicle.km with an average of 0.069 (+/-0.030) g/vehicle.km. The PM2.5 emission factor was similar to 74 of the PM10 factor. Speciated emission rates and chemical profiles for use in receptor modeling were also developed. PM2.5 was dominated by organic carbon (OC) (31.0 +/- 19.5) and elemental carbon (EC) (48.5 +/- 20.5) that together account for 79 (+/-24) of the total emissions. Crustal elements (Fe, Mg, Al, Si, Ca, and Mn) contribute similar to7.8, and the ions Cl-, NO3-, NH3+, SO42-, and K+ together constitute another 9.8. In the PM10 size fraction the particulate emissions were also dominated by OC (31 +/- 12) and EC (35 +/- 13). The third most prominent species was Fe (18.5 +/- 9.0), which is greater than would be expected from purely geological sources. Other geological components (Mg, All Si, K, Ca, and Mn) accounted for an additional 12.6. PM10 emission factors showed some dependence on vehicle speed, whereas PM2.5 did not. For test runs in which the average vehicle speed was 42.6 km/h a 1.7 times increase in PM10 emission factor was observed compared to those runs with an average vehicle speed of 72.6 km/h. Speciated emissions were similar. However, there is significantly greater mass attributable to geological material in the PM10, indicative of an increased contribution from resuspended road dust. The PM2.5 shows relatively good correlation with NOx emissions, which indicates that even at the low percent of HD vehicles, which emit significantly more NOx than ID vehicles, they may also have a-significant impact on the PM2.5 levels. References: 41

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号