AbstractActivation of pulps during acetylation, by prior mechanical or chemical treatment, has been investigated. The effect of degree of beating on the acetylation rate of wood and bagasse pulps has been studied. It is found that the acetylation rate of pulps increases when the degree of beating of pulps is increased to a definite degree, after which it slows down. The maximum reactivity of bagasse pulp is obtained at 50°SR, while that of wood pulp is observed at 30°SR. The effect of grafting of acrylonitrile onto bagasse and wood pulps on their reactivity during acetylation has been also studied. The results indicate that grafting of acrylonitrile onto pulps has a favorable effect on their acetylation rate. This is dependent on the degree of grafting as well as the origin of pulp fibers. The most suitable method of activation during acetylation reaction is dependent on the origin of the pulp. The reactivity of bagasse pulp during acetylation is influenced more by beating of pulp, prior to the reaction, than by the grafting of acrylonitrile onto pulp. On the other hand, the acetylation reaction of wood pulp is activated by grafting rather than by beating. Also the effect of the activation process, mechanical or chemical, on the strength properties of the paper sheets produced from acetylated pulps has been investigated. Chemical activation of wood pulp prior to acetylation resulted in pulp with slightly higher strength properties than that activated by mechanical means. But, in the case of bagasse pulp, mechanical activation resulted in a pulp with strength superior to that produced by chemical activatio
展开▼
