...
  • 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Proceedings of the Institution of Mechanical Engineers, Part L. Journal of Materials: Design and Application >Weld surfacing of aluminium alloy by Ni-Cr base alloys
【24h】

Weld surfacing of aluminium alloy by Ni-Cr base alloys

机译：Weld surfacing of aluminium alloy by Ni-Cr base alloys

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相关主题

摘要

This article describes the microstructure, microhardness, and the abrasive wear behaviour of the Ni-Cr base alloy overlays deposited on the Al-Zn-Mg alloy (7039) substrate by the shielded metal arc welding process. The weld overlays were deposited by using four levels of the welding current in the range from 110 to 140 A. Abrasive wear tests were carried out by using a pin-on-disc wear tester under a spiral wear track. Wear tests were carried out using three normal loads (5 N, 10 N, and 15 N) and abrasives of three grit sizes (120, 320, and 600 grade). Scanning electron microscopy, X-ray diffraction, and the energy dispersive analysis of X-rays studies were performed on the weld overlay to characterize the microstructure, composition, and phase analysis. It was found that from the microstructure point of view, three different zones are formed in the weld overlays. These zones exhibited significant variation in terms of the nickel and the aluminium content in the micro-constituents. The microhardness has been found to decrease from the top surface of the weld overlays to the base metal.

著录项

获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号