AbstractAn induction‐tuned device was designed and tested under a variety of well casing conditions. It can detect casing lengths to within 0.4 to 2.0 inches for casing ranging from 2 to 14 or more inches in diameter which are made of either magnetic or nonmagnetic metals. A casing separation as small as one inch is detectable for 12‐inch diameter casing and a four inch or more separation is detectable for 4‐inch I.D. casing. These values indicate the range in sensitivity expectable when determining casing separations.Dial readings in microamps are indicated as the ptobe is raised or lowered within a well bore. Readings vary depending whether the probe is centrally located or located to one side. The maximum and minimum dial reading is established for a given casing diameter at the start of a survey. A consistent change in dial reading from previous valves indicate a casing diameter change.The sensing element is a coil whose inductance is changed by varying its proximity to any metallic conductor. A coil and capacitor in parallel make a tuned circuit resonant at 3 K.C. The device includes a transistor in a phase shift oscillator, and a second transistor which acts as a current amplifier, a 0–100 μa d. c. meter driven through a bridge rectifier, capacitors, and other elements. Twelve to 14 volts at 4 to 6 milliamperes or less than 0.1 watt is sufficient to power the device.A maximum meter reading is obtained by adjusting an oscillator to the resonant frequency of the probe. Lowering the probe into a well casing detunes the probe, changing its impedance and the meter reading.All electrical elements are standard except the probe and all materials can be purchased for about $40.00 exclusive of the reel and cable
展开▼
