AbstractGlow discharge initiation of in situ polymerization of acrylic acid and other vinyl monomers incorporated in PET films was investigatigated. The influence of glow discharge conditions such as the gas used, plasma power, discharge current, and plasma treatment time on polymerization yield was determined. Though glow discharge effects are limited to the film surface, in situ polymerization of the vinyl monomers took place and the vinyl polymer could be found all through the film cross section. At short plasma treatment time only surface modification took place, while at longer treatment time bulk modification occurred, too. Good polymerization yields were obtained. Gel effect behavior was observed. Mechanical properties of the modified PET film were not changed, while the contact angle with water improved when polar vinyl monomers were used.
展开▼
