【24h】

STATIC AND DYNAMIC CORROSION EXPERIMENTS IN LIQUID LEAD-BISMUTH

机译:液体铅铋的静态和动态腐蚀实验

获取原文
获取原文并翻译 | 示例

摘要

Static and dynamic corrosion tests in liquid Pb-Bi eutectic were conducted to investigate applicability of metallic materials for an accelerator driven system which is being developed for transmutation of long-lived nuclear wastes. The static corrosion tests were performed in oxygen-saturated Pb-Bi at 450 and 550℃ for 3000h. The dynamic corrosion test was conducted using a liquid Pb-Bi loop where temperatures of high and low temperature parts were 450 and 400℃, and the flow rate of liquid Pb-Bi at the test section was about 1m/sec. In the static tests, the corrosion depth of F82H, Mod.9Cr-lMo steel and JPCA after immersion at 450℃ for 3000h was 14,13 and 5 μm, respectively. The thickness of the corrosion layer decreased with increasing Cr content of steels in the static corrosion test The corrosion depth of type 316ss at 450℃ was estimated to be about 100 μm after the test for 3000h in the Pb-Bi loop. It was also found that morphology of the interface faced to flowing Pb-Bi is different from that faced to static Pb-Bi. We observed the phenomena such as mass transfer, corrosion/erosion by flowing Pb-Bi, penetration of Pb-Bi into grain boundaries and dropping of grains in the dynamic corrosion test.
机译:进行了液态Pb-Bi共晶的静态和动态腐蚀试验,以研究金属材料在加速器驱动系统中的适用性,该系统正在开发用于长寿命核废料的trans变。在氧饱和的Pb-Bi中在450和550℃下进行了3000小时的静态腐蚀试验。动态腐蚀试验是使用液态Pb-Bi回路进行的,其中高温和低温部件的温度分别为450和400℃,并且在试验段处液态Pb-Bi的流量约为1m / sec。在静态试验中,F82H,Mod.9Cr-1Mo钢和JPCA在450℃下浸泡3000h后的腐蚀深度分别为14,13和5μm。在静态腐蚀试验中,腐蚀层的厚度随钢中Cr含量的增加而降低。在PB-Bi回路中进行3000h试验后,在450℃下316ss型的腐蚀深度估计约为100μm。还发现面对流动的Pb-Bi的界面形态不同于面对静态的Pb-Bi的界面形态。在动态腐蚀试验中,我们观察到了诸如传质,Pb-Bi流动引起的腐蚀/腐蚀,Pb-Bi渗入晶界以及晶粒掉落等现象。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号