首页> 外文会议>Thin film materials for large area electronics >Self-assembly of ultrathin composite TiO_2/polymer films
【24h】

Self-assembly of ultrathin composite TiO_2/polymer films

机译:超薄复合TiO_2 /聚合物薄膜的自组装

获取原文
获取原文并翻译 | 示例

摘要

A wet layer-by-layer self-assembly of composite TiO_2/polymer films on Si and Al_2O_3/Al, substrates has been studied by AFM, STM, and ellipsometry techniques. The quality of the first adsorbed TiO_2 layer has been found to be the governing factor in multilayer film growth. The first layer consists of single particles and particle agglomerates 30-120 nm wide The surface coverage in the layer is determined by the chemical composition of the substrate surface and water pH in post-adsorption rinsing procedure. Well-packed TiO_2/polymer film completely covering the surface has been prepared in five adsorption cycle on Al_2O_3/Al substrate. The film remained crack-free after heat treatment at 300 deg C. I-V curves measurement reveals high resistivity (R approx 10~10 O in the voltage range from -2 to +3 V) of TiO_2/polymer films prepared in ten adsorption cycles. direct c 1999 Elsevier Science S.A. All rights reserved.
机译:通过AFM,STM和椭偏技术研究了在Si和Al_2O_3 / Al衬底上的复合TiO_2 /聚合物薄膜的湿层自组装。已经发现第一吸附的TiO 2层的质量是多层膜生长的决定因素。第一层由单个颗粒和30-120 nm宽的颗粒团聚体组成。该层中的表面覆盖率由吸附后漂洗程序中基材表面的化学组成和水的pH值确定。在五个吸附循环中,在Al_2O_3 / Al基底上制备了完全覆盖表面的,堆积良好的TiO_2 /聚合物膜。该膜在300℃热处理后仍保持无裂纹。I-V曲线测量表明,在十个吸附循环中制备的TiO_2 /聚合物膜具有较高的电阻率(在-2至+3 V的电压范围内,R约为10〜10 O)。直接c 1999 Elsevier Science S.A.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号