首页> 中文期刊> 《煤化工》 >焦化废水中硫氰化物的快速检测方法

焦化废水中硫氰化物的快速检测方法

         

摘要

提出了一种能够实现现场多点多频率采样分析SCN-的方法,用于检测焦化废水处理厂沿程水样中SCN-的含量.研究结果表明,铁(Ⅲ)-硫氰化物分光光度法测试焦化废水中SCN-具有迅速、灵敏和稳定等优点,方法的最低检出质量浓度为0.1mg·L-1,测定上限为34.8mg·L-1,测量误差小于2.6%.由于所提出的方法具有显色反应灵敏度高以及检测下限较低的特点,应用于经稀释处理后的焦化废水水样,可消除干扰显色反应离子成分的影响,获得较好的测试重现性及回收率,满足水样现场检测的精度要求.%Quality control of the coking wastewater treatment requires real time monitoring and regulation of the concentrations of thiocyanate, since it is one of the major constituents of wastewater effluents. A method for multi-site and multi-frequency sampling and analysis was proposed for this purpose. Experimental results showed that the spectrophotometric method of ferric iron-thiocyanate complex had the advantages of rapid determination, high sensitivity and longterm stability in terms of its application for determining thiocyanate. This method had a lower detection limit of 0.1 mg/L and an upper detection limit of 34.8mg/L. The measurement errors were small with deviances less than 2.6%. It was found to be applicable to the determination of thiocyanate contained in the diluted coking wastewater samples where the influence of other ions on color reaction could be eliminated. In such a case, a good repeatability and a high recovery rate were obtained.

著录项

  • 来源
    《煤化工》 |2011年第1期|15-18|共4页
  • 作者单位

    广州市境天环保科技有限公司;

    广东;

    广州;

    510640;

    华南理工大学环境科学与工程学院;

    工业聚集区污染控制与生态修改教育部重点实验室;

    广东;

    广州;

    510006;

    华南理工大学环境科学与工程学院;

    工业聚集区污染控制与生态修改教育部重点实验室;

    广东;

    广州;

    510006;

    华南理工大学环境科学与工程学院;

    工业聚集区污染控制与生态修改教育部重点实验室;

    广东;

    广州;

    510006;

    华南理工大学环境科学与工程学院;

    工业聚集区污染控制与生态修改教育部重点实验室;

    广东;

    广州;

    510006;

    华南理工大学环境科学与工程学院;

    工业聚集区污染控制与生态修改教育部重点实验室;

    广东;

    广州;

    510006;

  • 原文格式 PDF
  • 正文语种 chi
  • 中图分类 脱硫与固硫;
  • 关键词

    焦化废水; 硫氰化物; 分光光度法; 分析检测;

相似文献

  • 中文文献
  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号