首页> 外文期刊>Journal of Applied Polymer Science >Effects of -CH_2CH_2CF_3 on properties of RTV polysiloxane rubber: Processability, thermal stability, and oil/solvent resistance
【24h】

Effects of -CH_2CH_2CF_3 on properties of RTV polysiloxane rubber: Processability, thermal stability, and oil/solvent resistance

机译:-CH_2CH_2CF_3对RTV聚硅氧烷橡胶性能的影响:可加工性,热稳定性和耐油/耐溶剂性

获取原文
获取原文并翻译 | 示例
           

摘要

Room temperature vulcanizing fluorosilicone rubbers (FSRs) were prepared from polydimethylsiloxane (PDMS), vinyl fluorosilicone-oil (VFS-oil), and precipitated silica (PDMS/VFS/SiO_2). Rheological tests showed appropriate processing condition could be obtained when shear rate > 10 s~(-1). Mechanical tests indicated that tensile strength and elongation at break were not much affected by VFS-oil and no decline was observed after being aged in 70 °C ASTM 1# oil. The -CF_3 group could not only increase oil-resistance, but also decrease surface energy, which were proved by ATR-FTIR and contact angle tests. The PDMS oil immersion tests showed that the higher the content of VFS-oil, the better oil resistance can be obtained. The solvent-resistance tests indicated that the VFS-oil improved resistance to nonpolar/low-polar solvent. TGA results showed that the increasing content of VFS-oil could slightly decrease FSRs' thermal stability but increase FSRs' residual mass ratio at 790°C.
机译:由聚二甲基硅氧烷(PDMS),乙烯基氟硅油(VFS-油)和沉淀二氧化硅(PDMS / VFS / SiO_2)制备室温硫化氟硅橡胶(FSR)。流变试验表明,当剪切速率> 10 s〜(-1)时,可获得适当的加工条件。力学测试表明,VFS油对拉伸强度和断裂伸长率影响不大,并且在70°C ASTM 1#油中老化后也未观察到下降。 -CF_3基团不仅可以提高耐油性,而且可以降低表面能,这已通过ATR-FTIR和接触角测试证明。 PDMS油浸测试表明,VFS油含量越高,可获得的耐油性越好。耐溶剂性测试表明,VFS油提高了对非极性/低极性溶剂的抗性。 TGA结果表明,增加VFS油的含量会稍微降低FSR的热稳定性,但会增加790°C下FSR的残余质量比。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号