...
  • 主题
高级搜索  >
历史搜索 清空历史
首页> 外文期刊>Journal of Alloys and Compounds: An Interdisciplinary Journal of Materials Science and Solid-state Chemistry and Physics >Optimization of processing conditions and characterization investigations of ceramic injection molded and sintered ZrO_2/WC composites
【24h】

Optimization of processing conditions and characterization investigations of ceramic injection molded and sintered ZrO_2/WC composites

机译：陶瓷注射成型和烧结ZrO_2 / WC复合材料的工艺条件优化和表征研究

获取原文
获取原文并翻译 | 示例
           
页面导航
  • 摘要
  • 著录项
  • 相似文献
  • 相关主题

摘要

In this investigation, 3mol% Y_2O_3 stabilized ZrO_2-based composites reinforced with 10vol.%, 20vol.% and 40vol.% WC (named as 3Y-TZP/10WC, 3Y-TZP/20WC and 3Y-TZP/40WC) were fabricated by using injection molding and sintering. Mechanical properties of these composites varied due to WC addition and dwelling time. Density, strength and toughness decreased with shorter dwelling time and increasing WC content however a significant enhancement in fracture toughness was obtained by 3Y-TZP/20WC composite which had 9.2 MPa m~(1/2) toughness. Severe unlubricated wear tests which were performed under 55 N normal load and 45 km sliding distance showed that 3Y-TZP/20WC composite had the lowest wear rate and wear volume values which are 2 x 10~(-8) mm~3/(N m~(-1)) and 0.05 mm~3, respectively.
机译：在这项研究中，通过以下方法制造了3mol％的Y_2O_3稳定的ZrO_2基复合材料，它们分别添加了10vol。％，20vol。％和40vol。％WC（分别称为3Y-TZP / 10WC，3Y-TZP / 20WC和3Y-TZP / 40WC）。使用注塑成型和烧结。这些复合材料的机械性能因加入WC和停留时间而异。随着停留时间的缩短和WC含量的增加，密度，强度和韧性降低，但是具有9.2 MPa m〜（1/2）韧性的3Y-TZP / 20WC复合材料获得了断裂韧性的显着提高。在55 N正常载荷和45 km滑动距离下进行的严重无润滑磨损试验表明，3Y-TZP / 20WC复合材料的磨损率最低，磨损量值为2 x 10〜（-8）mm〜3 /（N m〜（-1））和0.05 mm〜3。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱：kefu@zhangqiaokeyan.com

京公网安备：11010802029741号 ICP备案号：京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有

  • 客服微信

  • 服务号