...
【24h】

Does 3D volumetric analysis predict the reach of endoscopically harvested buccal fat pad flap

机译:3D容量分析是否预测内窥镜收获的颊脂垫襟翼的覆盖范围

获取原文
获取原文并翻译 | 示例
           

摘要

Objectives To determine if the volume of buccal fat, ascertained by computed tomography (CT) scanning, would correspond to surface area and reach (length and width) of the flap intraoperatively to aid in the reconstruction of selected skull base defects. Methods Cadaveric study of five specimens, 10 sides. Methods CT imaging and evaluation using the Osirix 9 software (Pixmeo; Bernex, Switzerland). of cadaveric heads to calculate the volume of the buccal fat bilaterally. The flap was then harvested endoscopically. Measurements were taken. Two heads were also dissected via a transfacial approach. Results The volume of the buccal fat pad (BFP) as well as the maximum length and width of the endoscopically harvested flap were documented. There was a positive correlation shown between the calculated volume of the BFP based on CT imaging and the dissected length and width of the flap (Pearson correlation, r = 0.83 and r = 0.80, respectively). The transfacial dissection demonstrated the lobes of the BFP well, showing that most of the endoscopic mobilization of the BFP was limited to the posterior lobe, in particular to the temporalis and pterygoid components, with minimal displacement of the superficial components. This minimized the risk of visibly hollowing the buccal fullness. Conclusion Preoperative calculation of the CT‐based volume of the BFP correlates positively with the intraoperative maximum reach of the flap for both length and width. Whereas the volume may be lower in some instances, the BFP would still have adequate reach to provide coverage for the lower and mid‐clival region in most patients. Level of Evidence NA. Laryngoscope , 130:1670–1673, 2020
机译:目的以确定通过计算机断层扫描(CT)扫描确定的颊脂的体积,对应于术中的表面积和延伸(长度和宽度),以帮助辅助选择的颅底缺陷的重建。方法尸体研究五个标本,10侧。方法使用Osirix 9软件CT成像和评估(PIXMEO; BERNEX,SWITZERLAND)。尸体头来计算双侧颊脂肪的体积。然后在内窥镜上收获翼片。测量是拍摄的。通过转敷方法也解剖两个头部。结果记录了颊脂垫(BFP)的体积以及内窥镜收获瓣的最大长度和宽度。基于CT成像的BFP的计算量和襟翼的解剖长度和宽度(Pearson相关性,r = 0.83和r = 0.80),存在正相关的正相关性。转敷解剖孔证明了BFP的裂片,表明BFP的大多数内窥镜摩托斯限于后叶,特别是颞叶和翼形组分,具有浅表性部件的最小位移。这最大限度地减少了明显挖空的风险。结论,BFP的CT基体积的术前计算与翼片的术中的最大覆盖率正相关,对于长度和宽度。然而,在某些情况下,体积可能较低,而BFP仍然可以达到足够的患者为下层和中际区域提供覆盖范围。证据级别。喉镜,130:1670-1673,2020

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号