...
首页> 外文期刊>Tribology Transactions >Relation Between Tribolayers and Wear Behavior During Dry Sliding of Fe-Al Hot-Dipped Coating
【24h】

Relation Between Tribolayers and Wear Behavior During Dry Sliding of Fe-Al Hot-Dipped Coating

机译:柴油热浸涂层干式滑动中零道与磨损行为的关系

获取原文
获取原文并翻译 | 示例
           

摘要

An Fe-Al coating consisting of FeAl and Fe3Al was prepared on AISI 1045 steel by hot-dip aluminizing and subsequent high-temperature diffusion. Dry sliding wear tests were performed for Fe-Al coating against AISI 52100 steel under various sliding speeds and loads. During sliding, thin tribolayers formed on the worn surfaces of the Fe-Al coating. After wear, they were observed to be a nonoxidized mechanically mixed layer (MML) at 0.5m/s, an oxide-containing MML at 0.75-2.68m/s, and an in situ oxide layer at 4m/s. The tribolayers presented a close relation with the wear behavior. Because of their different ingredients, structures, and types, the tribolayers resulted in significant changes in the wear behavior. At 0.75-2.68m/s (except for 2.68m/s, 40N), the compact tribooxide layers exerted a protective function for Fe-Al coating to reduce the wear rate. However, for the tribolayers containing no or trace tribooxides at 0.5m/s or the unstable ones formed at 2.68m/s, 40N and 4m/s, no protection was presented. In these cases, the Fe-Al coating would be partly or totally ground off, thus presenting poor wear resistance at high wear rates.
机译:通过热浸镀铝和随后的高温扩散,在AISI 1045钢上制备由FEAL和Fe3Al组成的Fe-Al涂层。在各种滑动速度和载荷下对AISI 52100钢进行Fe-Al涂层进行干滑动磨损试验。在滑动期间,在Fe-Al涂层的磨损表面上形成薄的骰子。磨损后,观察到它们是0.5m / s的非氧化机械混合层(MML),含氧化物的MML,在0.75-2.68m / s,含有4m / s的原位氧化物层。 Tridolayers与磨损行为提出了密切的关系。由于其不同的成分,结构和类型,仿生导致磨损行为的显着变化。在0.75-2.68m / s(2.68m / s,40n除外,紧凑的摩擦层施加了Fe-Al涂层的保护功能,以降低磨损率。然而,对于含有0.5m / s或2.68m / s,40n和4m / s形成的不稳定形式的亚致氧化物的横向氧化物,没有得到保护。在这些情况下,Fe-Al涂层将部分或完全接地,从而在高磨损率下呈现耐磨性差。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号