An important aspect of understanding industrial processing is to know the characteristics of the materials used in such processes. A study was performed to determine the effects of hydriding chamber material on the degree of hydriding for the commercial production of thin film hydride targets for various research universities, commercial companies, and government national laboratories. The goal was to increase the degree of hydriding of various thin film hydrides and to study the vacuum environment during air-exposure hydriding. For this purpose, dynamic residual gas analysis during deuterium gas hydride processing was utilized with erbium thin films, employing a special set-up for direct dynamic hydride gas sampling during processing at elevated temperature and full loading gas pressure. Complete process data for (1) a copper-(1.83wt.) beryllium wet hydrogen fired passivated (600 degrees C-1 h) externally heated pipe hydriding chamber are reported. Dynamic residual gas analysis comparisons during hydriding are presented for hydriding chambers made from (2) alumina (99.8 wt.), (3) copper (with an interior aluminum coating similar to 10 k angstrom thick, and (4) for a stainless-steel air-fired passivated (900 degrees C-1 h) chamber. Dynamic data with deuterium gas in the chamber at the hydriding temperature (450 degrees C) showed the presence and growth of water vapor (D2O) and related mixed ion species(H2O+, HDO+, D2O+, and OD+) from hydrogen isotope exchange reactions during the 1 h process time. Peaks at mass-to-charge ratios (i.e., m/e) of 12(C+), 16(CD2+), 17(CHD2+), and 18(CD3+, OD+) increased for approximately the first half hour of a 1 h hydriding process and then approach steady state. Mass-to-charge peaks at 19(HDO+) and 20(D2O+) continue to increase throughout the process cycle. Using the m/e = 20 (D2O+) peak intensity from chamber (1)-Cu(1.83 wt.) Be as a standard, the peak intensity from chamber (4)-stainless-steel (air-fired) was 7.1x higher, indicating that the surface of stainless-steel had a larger concentration of reactive oxygen and/or water than hydrogen. The (D2O+) peak intensity from chamber (3)-Cu (interior Al coating) was 1.55x larger and chamber (2)-alumina(99.8) was 1.33x higher than Cu(1.83 wt. ) Be. Thus copper-(1.83 wt. ) beryllium was the best hydriding chamber material studied followed closely by the alumina (99.8 wt. ) chamber. Gas take-up by Er occluder targets processed in Cu(1.83 wt.) Be hydriding chambers (i.e., gas/metal atomic ratios) correlate with the dynamic RGA data. (C) 2014 American Vacuum Society.
展开▼
