...
首页> 外文期刊>Experimental Thermal and Fluid Science: International Journal of Experimental Heat Transfer, Thermodynamics, and Fluid Mechanics >Experimental analysis of pressure distribution in a twin screw compressor for multiphase duties
【24h】

Experimental analysis of pressure distribution in a twin screw compressor for multiphase duties

机译:双螺杆压缩机多相工况压力分布的实验分析

获取原文
获取原文并翻译 | 示例
           

摘要

This paper presents the results of an experimental investigation of pressure distribution inside working chamber of a twin screw compressor for multiphase duties. A mathematical model for describing the pressure distribution inside working chamber is proposed. By means of a small pressure transducer embedded into the groove at the root of the rotor, the pressure distributions of a multiphase compressor under various running conditions have been recorded successfully to verify the model. It is found that the pressure curve during the discharge process has a higher level under the conditions of the lower gas void fraction, higher discharge pressure, higher rotational speed and higher inlet pressure. The pressure distribution calculated by model in this paper shows good agreement with the data recorded by a small pressure sensor in a prototype multiphase compressor at the high gas void fractions under different operating conditions.
机译:本文介绍了用于双相压缩机的双螺杆压缩机工作室内压力分布的实验研究结果。提出了描述工作室内压力分布的数学模型。通过嵌入转子根部凹槽中的小型压力传感器,已成功记录了多相压缩机在各种运行条件下的压力分布,从而验证了模型。发现在较低的气体空隙率,较高的排放压力,较高的旋转速度和较高的入口压力的条件下,排放过程中的压力曲线具有较高的水平。通过模型计算得出的压力分布与原型多相压缩机中在不同工作条件下高气隙率下小型压力传感器记录的数据显示出良好的一致性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号