首页> 外文会议>JSAE/SAE International Powertrains, Fuels and Lubricants Meeting >Influence to the PN Emissions in Calibration Procedure for Portable and Stationary Solid Particle Number Measurement Systems
【24h】

Influence to the PN Emissions in Calibration Procedure for Portable and Stationary Solid Particle Number Measurement Systems

机译:对便携式和静止固体粒子数测量系统校准过程中PN排放的影响

获取原文

摘要

The Real Diving Emissions (RDE) regulation has been introduced since September, 2017 by utilizing the Portable Emissions Measurement System (PEMS). For the PEMS for the solid Particle Number (PN) measurement (PN-PEMS), the validation tests are required by comparing to the stationary PN measurement system on a chassis dynamometer prior to the on-road emissions testing. However, there are some cases that the emission results of PN-PEMS have big difference for that of the PMP system as the PN-PEMS does not have the same system configuration and calibration procedures as a PMP system. In this paper, the influence of the calibration procedure to the PN emissions results was observed by applying the calibration procedure of the PN-PEMS to the PMP system. The current systems configurations for PMP system and PN-PEMS, and the differences of them were described. And, the calibration procedure of the PN-PEMS was applied to the PMP system to adjust the system detection efficiency at 23 nm. Finally, the influence of the calibration protocol was investigated by compared the PN emissions of PMP system and the on PN-PEMS.
机译:自2017年9月以来,通过利用便携式排放测量系统(PEMS)以来,潜水排放量(RDE)规范已经推出。对于用于固体粒子数(PN)测量的PEM(PN-PEMS),通过在路上排放测试之前将底盘测功机上的固定PN测量系统比较来验证测试。然而,存在一些情况下,PN-PEMS的发射结果对于PMP系统的发射结果具有很大的差异,因为PN-PEM没有与PMP系统相同的系统配置和校准程序。本文通过将PN-PEMS的校准程序应用于PMP系统,观察到校准过程对PN排放结果的影响。描述了PMP系统和PN-PEM的当前系统配置以及它们的差异。并且,PN-PEMS的校准程序应用于PMP系统,以在23nm处调整系统检测效率。最后,通过比较PMP系统的PM排放和PN-PEMS的PN排放来研究校准方案的影响。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号